Tube Assembly And Truss Assembly - Meridian SLMD SERIES Assembly And Parts List

TUBE ASSEMBLY AND TRUSS ASSEMBLY

1. Connect tube assembly A to tube assembly B as
shown in (FIGURE 01), ensure proper alignment
of flight assemblies. Note: For the SLMD12-79
and SLMD12-85, there are three tube assemblies
to connect.
2. Lift BOOT END of TRUSS ASSEMBLY
min. 24" high.
3. Assemble truss risers (FIGURES 03, 04 and 05)
in the order indicated (FIGURE 01)
4. Position one SHORT CABLE and one LONG
CABLE straight and flat on floor and to the left
and right side of the tube assembly.
5. Install SHORT CABLE spanning from (FIGURE
03 to 05). See (FIGURE 01). Fasten to (FIGURE
5
05) first using " dia. bolt, flat washer and
8
bushing. Tighten.
6. Fasten SHORT CABLE to bottom two holes in
(FIGURE 04) using
Leave loose.
7. In (FIGURE 03) partially thread one of the two
nuts to eyebolt while attaching eyebolt to TUBE
SADDLE.
8. Thread SHORT CABLE through eyebolt and pull
5
tight. Attach two
in (FIGURE 03)
9. Tighten partially threaded nut on eyebolt until
adequate tension is achieved on SHORT CABLE.
10. Thread second nut to eyebolt and lock.
11. Repeat steps 5 - 10 to install second SHORT
CABLE.
12. Install LONG CABLE spanning from (FIGURE 02
to 06). See (FIGURE 01). Fasten to (FIGURE 06)
5
first using " dia. bolt, flat washer and bushing.
8
Tighten.
3
" cable clamp and nuts.
8
" cable clamps as shown
16
ASSEMBLY
13. Fasten LONG CABLE to top two holes in
(FIGURE 03, 04 and 05) using
and nuts. Leave loose.
14. In (FIGURE 02) partially thread one of two
nuts to eyebolt while attaching eyebolt to TUBE
SADDLE.
15. Thread LONG CABLE through eyebolt and pull
tight. Attched two
in (FIGURE 02).
16. Tighten partially threaded nut on eyebolt until
adequate tension is achieved on LONG CABLE.
17. Thread second nut to eyebolt and lock.
18. Repeat steps 12 - 17 to install second LONG
CABLE.
19. Lower BOOT END to floor and tighten all truss
riser cable clamps.
20. Refer to SET-UP PROCEDURES page B1 step 2
for the next set of instructions.
B2
13000003449-20-01
3
" cable clamp
8
5
" cable clamps as shown
16