Assembly; Set Up Procedure - Meridian SLMD SERIES Assembly And Parts List

1. Follow and complete steps 1 through 20 on
page B2 using page B3 reference drawings
and then proceed to step 2 on this page.
2. Follow and complete steps 1 through 8 on
page B4 and then proceed to step 3 on this
page.
3. Follow and complete steps 1 through 4 on
page B5 and then proceed to step 4 on this
page.
4. Follow and complete steps 1 through 8 on
page B6 and then proceed to step 5 on this
page.
5. Follow and complete steps 1 through 6 on
page B7 and than proceed to step 6 on this
page.
6. Place assembled (FIGURE 9) under
assembled (FIGURE 1). Connect the two
assemblies with two 1" dia. x 2-1/2" bolts
and lock nuts. NOTE: Refer to (FIGURE 1)
for the top lift frame assembly mounting
location. Proceed to step 7 on this page.
7. Lift the now assembled (FIGURE 1 & 9)
together and position it over the partially
assembled (FIGURE 10). Line up bottom
of top lift frame to the top of the bottom
lift frame. Install a pivot bushing to each side.
Fasten the assemblies together at each side
with 1" dia. x 8" bolt, two plated washers and
a lock nut. Proceed to step 8 on this page.
8. Raise the auger tube assembly and then
continue with steps 7 through 17 on page B7
before proceeding with step 9 on this page.

ASSEMBLY

SET UP PROCEDURE

13000003449-19-01
9. Follow and complete steps 1 through 6 on
page B8, and then proceed to step 10 on
this page.
10. Hydraulic lines:
Short Line connected to upper steel hydraulic
line and hydraulic cylinder.
Connect valve to the lower steel hydraulic
line and then attach long line to valve.
Complete long line assembly with pioneer
tip.
Proceed to step 11 on this page.
11. Follow and complete steps 5 through 9 on
page B5 and then proceed to step 12 on
this page.
12. Follow and complete steps 1 through 7 on
page B9 and then proceed to step 13 on
this page.
13. Follow and complete steps 1 through 8 on
page B10 and then proceed to step 14 on
this page.
14. Check that all bolts are tightened, pins are
in place, fittings are greased and that all
safety guards and shields are installed.
Ensure proper air pressure in all tires.
B1