Sony MZ-N10 Notes: installing & operating OpenMG Service Manual page 22

MZ-N10
Power Supply Adjustment Auto Item Feed
Note : This mode is available to perform the temperature correc-
tion and power supply adjustment without entering the
manual mode.
• Setting method of power supply adjustment auto item
feed mode.
1. Set the test mode (see page 11)
[VOL --]
2. Press the . or
ment mode.
Remote commander LCD display
000
Assy**
3. Turn the jog dial (up), or press the
remote commander to set the temperature correction mode.
Remote commander LCD display
015
SetTmp
** : Adjusted value
4. To change the initial value (hexadecimal), adjust with the
+] [VOL --]
or key.
Press the X key to write the adjusted value, and the item
number increases automatically.
When not writing the adjusted value, press the > key to
move to the next item.
Remote commander LCD display
741
VC1 L
** : Adjusted value
Configuration of power supply adjustment auto item feed
.
.
.
.
.
.
.
.
22
key to activate the overall adjust-
[P MODE]
key on the
@
**
[VOL
**
000Assy **
The jog dial (up) or
P MODE key on the remote
015 SetTmp 19
key
>
key
741 VC1 L **
key
>
key
742 VC1 H **
key
>
key
743 VC2 Lo **
key
>
key
744 VC2 Hi **
key
>
key
745 REG1 **
> key
key
746 REG2 **
key
>
key
747 REG3L1 **
key
>
key
5. Connect a digital voltmeter to the test points on the MAIN
board, and adjust the voltage with the
key. (see page 18 to 20)
Press the X key to write the adjusted value, and the item
number increases automatically.
6. When not writing the adjusted value, press the > key to
move to the next item.
The . key is available to back to the last item.
7. The following message is displayed after all power supply ad-
justments finish.
Remote commander LCD display
000
ADJ OK
8. Press the x key to return to the test mode (display check
mode).
748 REG3L2 **
commander
. key
749 REG3 H **
key
.
751 VREC L **
key
.
752 VREC M **
key
.
753 VREC H **
key
.
754 3.3upc
key
.
755 ChgV L **
key
.
756 ChgV H **
. key
757 CIL **
000 ADJ OK
[VOL +] [VOL --]
or
key
>
key
>
key
>
key
>
key
>
**
> key
key
>
key
>
key
>