Replacing Curve Control Device - Invacare CometALPINE+ Service Manual

Replacing steering link/coupling rod
1.
Remove circlip (1) on steering link (2).
2. Replace steering link.
3. Adjust length of steering link using setting screws (3).
4. Remove circlip (4) on coupling rod (5).
5. Replace coupling rod.
6. Install parts of steering link and/or coupling rod in
reverse order.
7. Test all functions (trial run).
Adjusting camber
1. Loosen screws A.
2.
Spin steering link up by 0,5 cm. Wheels stand turned
inwards by 1° C from neutral position B.
3. Install parts of steering link and/or coupling rod in
reverse order.
4. Test all functions (trial run).

5.9.4 Replacing curve control device

CAUTION!
Risk of accident
Accidental rolling can lead to accidents.
– Secure mobility device against rolling away.
When disassembling, note the position of small
parts such as screws and washers. Put small parts
down so that they can be reassembled in the right
sequence.
• Phillips screwdriver
• 32 mm wrench
1. Remove seat.
2. Remove shroud.
1603798-D
3.
Disconnect battery cable A.
4.
Remove front shroud colored cap A.
5. You can see curve control device C through opening
D.
6. Remove screw B that fixes shroud between front
wheels.
7.
To check position of sensors of curve control device,
use measuring gauge A supplied in "Bend speed
reducer retrofitting kit".
Service
29