Lighting Unit; Replacing Headlight; Replacing Front Direction Indicators - Invacare CometALPINE+ Service Manual

Invacare® Comet Series
1. Remove rear shroud. See 5.6.1 Removing shroud,
page 19.
2.
Remove four caps A.
3. Loosen and remove screws B.
4. Take off front shroud.
5. Install parts in reverse order.

5.7 Lighting unit

5.7.1 Replacing headlight

You can replace headlight without removing the
chassis. If, however, the working space is too small,
you can remove the chassis as described in chapter
5.8.4 Replacing steering column, page 24.
• Phillips screwdriver
1. Remove seat.
2. Remove shroud.
3.
Disconnect battery cable A.
4. Remove rear steering column shroud. See 5.8.4
Replacing steering column, page 24.
5.
Remove screw A on headlight under front shroud.
20
6. Disconnect direction indicator cable B at wiring
harness behind steering column shroud.
7.
Remove headlight.
8. Remove screws (1) on headlight glass.
9. Remove headlight glass.
10. Replace bulb (2) in headlight.
11. Install parts in reverse order.
12. Test all functions.

5.7.2 Replacing front direction indicators

• Phillips screwdriver
1. Remove seat.
2. Remove shroud.
3.
Disconnect battery cable A.
4.
Remove direction indicator screw A on housing.
5. Disconnect direction indicator cable B from wiring
harness.
1603798-D