Ricoh Pro C901S Replacement Manual page 6

Hide thumbs Also See for Pro C901S:
Table of Contents

Advertisement

Handling the machine's interior
This section explains safety precautions about handling the machine's interior.
WARNING
• Do not allow paper clips, staples, or other small metallic objects to fall inside
the machine.
• The inside of this machine gets very hot. Do not touch the parts with a label
indicating the "hot surface". Otherwise, an injury might occur.
• The fusing section of this machine gets very hot. Caution should be taken
when removing misfed paper.
Handling the machine's supplies
This section explains safety precautions about handling the machine's supplies.
WARNING
• The fusing unit becomes extremely hot during operation, so to prevent minor
burns, turn the machine off and allow it to cool for at least 30 minutes before
you remove the fusing unit.
• The fusing unit weighs approximately 29 kg (63.9 lb.) so two people are
required to lift and move it. Handle it carefully when you remove it to avoid
dropping it and causing damage or minor injuries.
• Before replacing the developer, make sure that the machine's parts are all
closed.
CAUTION
• Keep toner (used or unused) and toner containers out of reach of children.
• Do not use aluminum foil, carbon paper, or similar conductive paper to avoid a
fire or machine failure.
• If toner or used toner is inhaled, gargle with plenty of water and move into a
fresh air environment. Consult a doctor if necessary.
• If toner or used toner gets into eyes, wash eyes immediately using lots of
water. Consult a doctor if necessary.
• If toner or used toner is swallowed, dilute it by drinking lots of water. Consult a
doctor if necessary.
• Avoid getting toner on your clothes or skin when removing a paper jam or
replacing toner. If your skin comes into contact with toner, wash the affected
area thoroughly with soap and water.
• If toner gets on your clothing, wash it using cold water. Hot water will set the
toner into the fabric and might make removing the stain impossible.
• When removing used toner filter, avoid getting toner (new or used) on your
skin. If toner comes into contact with your skin, wash the affected area
thoroughly with soap and water. Hot water will set the toner into the fabric and
make removing the stain impossible.
6

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pro c901

Table of Contents