Before You Begin; What You Need - Ricoh Pro C901S Replacement Manual

1. Before You Begin

This manual is only for operators who have received training in the procedures
shown in this manual. General users are not to perform the procedures shown in
this manual.
• Never perform any procedure in this manual if you have not received proper
training.
• If you have received training and are not sure about how to do a procedure then
call for service.
• Even if you have received training, never attempt any procedure that is not
shown in this manual.
• Contents of this manual are subject to change without prior notice. In no event
will the company be liable for direct, indirect, special, incidental, or consequential
damages as a result of handling or operating this machine.

1.1 What You Need

Use only the tools and materials described in this manual. Use of other tools or
materials could damage the machine or cause injury.
You will need the following items:
• Accessory hex screwdriver
screws from the machine. The black screws in the machine are the only
screws that should be removed.
• Drum setting powder pad applicator (provided). Needed to apply a thin coated of
powder on the drum.
• Newspaper or other paper. Needed to cover your work surface and prevent toner
spillage from components removed from the machine.
Important: The accessory hex screwdriver and drum setting powder pad are
included in the kit that is supplied this machine. Keep this kit in a safe place where
you can find it later. If the kit is not available, contact your supervisor or call for
service.
Accessory hex screwdriver
Black hex screws
3 Developer bottle
4 Drum setting powder pad applicator
RPG017S
(provided). Needed to remove the black hex
10