Quick Access Function (Softkey Menu) - DURKOPP ADLER 650-10 Operating Instructions Manual

42
Symbol Meaning
Stitch length
Value range: 1.0 – 4.0 mm
• Use
• Use
Thread tension
Value range: 1 – 99
• Use
• Use
Curve support
Value range: 0 – 6
• Use
• Use
Other parameters
( p. 44)
Seam length in mm
After the thread has been cut, the display is retained.
Measurement restarts when sewing starts again.
Switch between upper
and lower fullness
ESC, F, S, OK No function assigned
0 – 16 Fullness values
5.3.1

Quick access function (softkey menu)

Here you have quick access to functions during the sewing pro-
cess and can also assign a function to the upper softkey.
To open the softkey menu:
1. Press the lower softkey
 The following appears on the display:
Service settings via software (OP3000)
 
/ to select the parameter
 
/ to change the stitch length
 
/ to select the parameter.
 
/ to change the thread tension
 
/ to select the parameter
 
/ to change the curve support
.
Operating Instructions 650-10 - 03.0 - 08/2016