Deleting The Sewing Program - DURKOPP ADLER 650-10 Operating Instructions Manual

60
Select another program number using 
program number using the keypad keys 0 – 9 and then
press the OK key.
 The program number is loaded.
The display shows the following information,
the P in the program number field flashes:
Fig. 37: Copying the sewing program (3)
4. Load the desired changes into the new sewing program.
5. Press the ESC key.
 The controller switches to Edit mode to Automatic mode.
5.6.4

Deleting the sewing program

The selected sewing program is deleted.
Proceed as follows to delete an existing sewing program:
1. Press the
 The softkey menu appears on the display:
Fig. 38: Deleting the sewing program
2. Press the
3. Press the ESC key.
 The controller switches to Edit mode to Automatic mode.
Service settings via software (OP3000)
key.
key.
Operating Instructions 650-10 - 03.0 - 08/2016
 or input a
/