Sony 3-299-549-11(1) Operating Instructions Manual page 108

The S-AIR function
Symptom
S-AIR connection is not
established (sound transmission
is not established), e.g., the
indicator of the S-AIR sub unit
does the following:
• Turns off.
• Flashes.
• Turns red.
No sound is heard from the
S-AIR sub unit.
There is noise or the sound skips. • If you use another S-AIR main unit, place it more than 8 m away from this
108
GB
Remedy
• If you use another S-AIR main unit, place it more than 8 m away from this
S-AIR main unit.
• Confirm the ID of the S-AIR main unit and S-AIR sub unit (page 75).
• You performed pairing the S-AIR main unit and another S-AIR sub unit.
Perform pairing of the desired S-AIR sub unit (page 77).
• The S-AIR main unit is paired to another S-AIR sub unit. Cancel pairing.
• Install the S-AIR main unit and S-AIR sub unit away from other wireless
products.
• Stop using another wireless product.
• The S-AIR sub unit is turned off. Make sure the AC power cord (mains lead)
is connected and turn on the S-AIR sub unit.
• If you use another S-AIR main unit, place it more than 8 m away from this
S-AIR main unit.
• Confirm the ID of the S-AIR main unit and S-AIR sub unit (page 75).
• Confirm the pairing setting (page 77).
• Install the S-AIR main unit and S-AIR sub unit closer together.
• Avoid use of equipment that generates electromagnetic energy, such as a
microwave oven.
• Install the S-AIR main unit and S-AIR sub unit away from other wireless
products.
• Stop using another wireless product.
• Change the "RF CHANGE" setting (page 79).
• Change the ID settings of the S-AIR main unit and S-AIR sub unit.
• Turn off the system and S-AIR sub unit, then turn on them.
S-AIR main unit.
• Install the S-AIR main unit and S-AIR sub unit closer together.
• Avoid use of equipment that generates electromagnetic energy, such as a
microwave oven.
• Install the S-AIR main unit and S-AIR sub unit away from other wireless
products.
• Stop using another wireless product.
• Change the "RF CHANGE" setting (page 79).
• Change the ID settings of the S-AIR main unit and S-AIR sub unit.