DURKOPP ADLER 650-16 Operating Instructions Manual page 61

Control with the OP3000 control panel
Operating Instructions 650-16 - 02.0 - 08/2016
Fig. 34: Creating a program (3)
If necessary change the sleeve side or other parameters, 
4.
5.7 Edit mode, page 52.
5. Press the
 The following display appears, with P flashing:
Fig. 35: Creating a program (4)
The rest of the procedure is as described in the section Quick
programming ( p. 49).
6. Select whether progression to the individual steps to be pro-
grammed should be by using the knee switch or by automatic
progression.
7. Press the
Once the creation of the program is complete and the "S" key has
been pressed or after the thread cutoff has been entered, the
following query window appears:
Fig. 36: Creating a program (5)
8. Select whether
• the sleeve side that was programmed should be mirrored
• the sleeve side that was programmed should not be mirro-
red
• the teach-in for the 2nd sleeve side should be opened.
key.
key.
59