Table of Contents
Advertisement
1 Sealing gasket
2 Surface contacting the sealing gasket
Confirm that the sealing gasket and its mating surfaces have not become scratched. Even a small scratch may
lead to water entering the camera. If the sealing gasket or its mating surfaces become scratched, take the
camera to an authorized repair shop to have the sealing gasket replaced for a fee.
If dirt or sand gets on the sealing gasket or its mating surfaces, wipe the area clean with a soft cloth that will not
leave behind any fibers.
Prevent the sealing gasket from becoming scratched by touching it while charging a battery or using a cable.
Notes on using the camera under/near water
The water-proof/dust-proof performance is not ensured when the battery cover or memory card/connector cover is
open.
Do not open and close the battery cover or memory card/connector cover while under/near water.
Do not subject the camera to shock such as from jumping into water.
This camera sinks in water. When using, place your hand through a strap, etc. to prevent the camera from sinking.
The surface of the monitor may dent at depths of around 10 m (33 ft.) due to water pressure. This is not a
malfunction.
Also refer to
"Shooting images
Cleaning after using the camera under/near water
Do not open the battery cover or memory card/connector cover before cleaning is finished. Sand or water may get
inside places where it cannot be seen. If not rinsed, water-proof performance will be degraded.
Always clean the camera with water within 60 minutes of use, as follows:
Allow the camera to sit in pure water poured into a cleaning bowl for about 5 minutes. Then, gently shake the
camera, press each button inside the water, to clean away any salt, sand or other matter lodged around the
buttons. Bubbles may appear when the camera is placed under water. This is not a malfunction.
After rinsing, wipe off any water droplets with a soft cloth. Place the camera on a dry cloth with the lens side
down, and let it sit until the water drains out. Then, allow it to dry completely in a shaded location with good
ventilation.
Wipe water drops or dust off the battery cover and memory card/connector cover with a soft, dry cloth.
Do not blow dry with a hair dryer as there is a risk of deformation and/or degraded water-proof performance.
If audio cannot be recorded or is recorded at a low volume after cleaning, there may still be water inside the internal
microphone. Let water drain from the camera completely before use.
The camera body may become discolored if it comes in contact with sunscreen or suntan oil. In addition, the sealing
gasket may deteriorate if it comes in contact with sunscreen or suntan oil. If the camera does come in contact with
sunscreen or suntan oil, quickly wipe it clean.
Do not allow the camera to sit with salt water inside or on the surface. This may lead to corrosion or discoloration,
and degradation of water-proof performance.
To maintain the water-proof performance, we recommend that once a year you take the camera to your dealer, or to
an authorized repair shop, to have the sealing gasket of the battery cover or memory card/connector cover replaced
for a fee.
Related Topic
Shooting images underwater
underwater" for the appropriate settings for shooting underwater.
281
Advertisement
Table of Contents
