Table of Contents
Advertisement
(B): Access point
(C): Camera (client)
Connect the client to the access point by performing the following procedure.
If the access point has a Wi-Fi Protected Setup (WPS) button:
1.
On the camera, execute [
You can also execute [
[Access Point(Client)] → [OK].
2.
Press the WPS button on the access point.
If the access point does not have a Wi-Fi Protected Setup (WPS) button:
1.
On the camera, execute [
You can also execute [
[Access Point(Client)] → [OK].
2.
Select an access point to connect.
If the desired access point is not displayed on the screen, select [Manual Setting] and input the SSID of the
access point. Then, select the security method.
3.
Input the password, and select [OK].
Access points without the
4.
Select [Auto] or [Manual] for [IP Address Setting], and select [OK].
If you select [Manual], input [IP Address]/[Subnet Mask]/[Default Gateway] according to the network
environment.
Connect the smartphone to the access point, and launch Imaging Edge Mobile on the smartphone.
3
Hint
By selecting MENU →
to connect.
By selecting MENU →
smartphone. Use this function when you want to distinguish between different cameras.
Note
The Wi-Fi function is deactivated in the following situations:
When [
File Format] is set to [XAVC S 4K]
When [
File Format] is set to [XAVC S HD] and [
When using [Interval Shooting]
WPS Push] from the [Access Point(Client)] screen.
WPS Push] by selecting MENU →
Access Point Set.] from the [Access Point(Client)] screen.
Access Point Set.] by selecting MENU →
mark do not require a password.
(Network) → [Ctrl w/ Smartphone] → [Access Point(Client)], you can check or change the access point
(Network) → [Edit Device Name], you can change the name of the camera displayed on the
(Network) → [Ctrl w/ Smartphone] →
Record Setting] is set to [120p]/[100p]
237
(Network) → [Ctrl w/ Smartphone] →
Advertisement
Table of Contents
