Other Problems - Roland MUSIC ATELIER Series Owner's Manual

Troubleshooting
Problems with playback functions
Problem
Moving your hand over the D Beam
controller does not produce a sound
Damper Pedal does not operate
Expression Pedal does not operate
Can't use the function assigned to the foot
switch
Problems with the audio files
Problem
Can't play an audio file
Can't record along with an audio file/
Can't copy an audio file to internal memory

Other problems

Problem
Can't read/write USB memory
118
Cause
If a D Beam button is lit in red, moving your hand
above the D Beam controller will apply an effect to
the sound you play from the keyboard.
The damper pedal affects only the Lower
keyboard. The damper pedal does not affect the
Upper Keyboards and Bass pedalboard.
The damper pedal does not affect the Solo voice.
The function of the Expression Pedal during
recording or the function during playback has
been set to "COMPOSER. "
If "Registration Shift" (change Registrations)
is "RIGHT, " "LEFT, " or "RIGHT + Load Next, " the
foot switch will be dedicated to switching the
Registration.
Cause
Is the audio file in a format supported by the
ATELIER?
To be playable, audio files must be in the following
format.
• File name extension is ".wav"
• 16-bit linear sampling
• Sampling rate is 44.1 kHz
The ATELIER does not allow recording using audio
files, and cannot be used to copy audio files into
internal memory.
Cause
Could you be using USB memory not made by
Roland?
The USB memory setting is incorrect.
Action
Press the D Beam button once again so the button
is lit in green.
This is not a malfunction.
This is not a malfunction.
Set the expression pedal function during record-
ing to "PEDAL, " and during playback to "PEDAL" or
"PEDAL+COMPOSER. "
Turn "Registration Shift" off.
Action
This is not a malfunction.
This is not a malfunction.
Action
We cannot guarantee operation if you're using
USB memory not made by Roland.
Change the USB Memory setting.
Page
p. 44
- - -
- - -
p. 94
p. 96
Page
- - -
- - -
Page
- - -
p. 104