X524 Electronics Power Supply; Meaning Of The Leds - Siemens SINAMICS Equipment Manual

5.1.2.6

X524 Electronics power supply

Table 5-6
Type: Screw terminal 2
The maximum cable length that can be connected is 30 m.
Note
The two "+" and "M" terminals are jumpered in the connector. This ensures that the supply
voltage is looped through.
The digital outputs are supplied via terminals X520, X521, and X522.
5.1.3

Meaning of the LEDs

Table 5-7 Meanings of the LEDs on the Terminal Module TM15
LED Color
READY -
Green
Orange
Red
Green/re
d
Green/
orange
or
Red/
orange
See List Manual for the parameter to activate the recognition of components via LED
1)
Supplementary component descriptions
Manual, 06/2019
X524 electronics power supply
Terminal
+
+
+
M
M
Status
Off The electronics power supply is missing or outside the per‐
missible tolerance range.
Continuous The component is ready for operation. Cyclic DRIVE-CLiQ
light communication is taking place.
Continuous DRIVE-CLiQ communication is being established.
light
Continuous This component has at least one fault.
light
Note:
The LED is activated regardless of whether the corresponding
messages have been reconfigured.
Flashing Firmware is being downloaded.
light 0.5 Hz
Flashing Firmware download has been completed. The system waits
light 2 Hz for POWER ON.
Flashing Component recognition via LED is activated
light
Note:
Both options depend on the LED status when component rec‐
ognition is activated.
Designation
Electronics power supply
Electronics power supply
Electronics ground
Electronics ground
Description, cause
Terminal Modules
5.1 Terminal Module TM15
Technical data
Voltage: 24 V DC (20.4 ... 28.8 V)
Current consumption: max. 0.6 A
(including DRIVE-CLiQ and control of
digital outputs)
Max. current via the jumper in the con‐
nector: 20 A (15 A according to UL/CSA)
–
–
–
Remove and ac‐
knowledge the fault.
–
Carry out a POWER
ON.
. –
1)
Remedy
59