Connecting A Dvd Player With S Video And Audio Connectors - Sony KE-42M1 Operating Instructions (primary manual) Operating Instructions Manual

Television - plasma: 42" flat panel color tv (plasma wega™)
Hide thumbs Also See for KE-42M1 Operating Instructions (primary manual):
Table of Contents

Advertisement

Connecting a DVD Player with S Video and Audio
Connectors
Use this hookup if:
° Your DVD player does not have component
(Y, Ps, PR).jacks.
Tip
If your DVD player
has component
video output
connectors,
for best picture
quality,
use the
connection
described
on page 27.
The Y, Ps and Pajacks
on your DVD player
are sometimes
labeled
as Y, Cs and C_, or Y, B-Y
and R-Y. If so, connect
the cables to the matching
colors.
Disconnect
all power
sources
before
making any connections.
1
Using an AUDIO cable, connect the DVD player's
AUDIO OUT jacks to
the TV's AUDIO IN jacks.
2
Using an S VIDEO cable, connect the DVD player's
S VIDEO OUT jack
to the TV's S VIDEO IN jack (VIDEO
IN 1 or 3).
Rear of TV
AUDIO cable --
(not supplied)
2
S VIDEO
cable
(not supplied)
__
t
VIDEO
AUDIO-L
(red)
0
DVD player
Note
When you connect video equipment
to both the VIDEO
and the S VIDEO
input jacks, make
,,
"Auto YC ' in the _
(Setup)
menu is set to "On' to view the S VIDEO input
sure
(see page
23).
Tips
• You can also use the VIDEO
1N 2 jacks
located
on the front of'the
TV to connect
your
DVD player.
• To take advantage
of the Wide Screen Modes,
set the aspect ratio of the output signal to
16:9 on your DVD player.
For details,
refer to the operating
instructions
supplied
with your
DVD player.
• Use VIDEO
1/2/3 on the remote
control
to switch to the DVD player
input.
• If your DVD player
is not equipped
with S VIDEO,
use a VIDEO
cable (yellow)
instead
of
the S VIDEO
cable.
28

Advertisement

Table of Contents
loading

Table of Contents