Connecting A Dvd Player With S Video And Audio Connectors - Sony KE-42M1 Service Manual

Connecting a DVD Player with S Video and Audio
Connectors
A/V cable
(not supplied)
28
Use this hookup if:
• Your DVD player does not have component (Y, P
Tips
• If your DVD player has component video output connectors, for best picture quality, use the
connection described on page 27.
• The Y, P
B-Y and R-Y. If so, connect the cables to the matching colors.
• To take advantage of the Wide Screen Modes, set the aspect ratio of the output signal to
16:9 on your DVD player. For details, refer to the operating instructions supplied with your
DVD player.
Disconnect all power sources before making any connections.
1
Using an A/V cable, connect the DVD player's AUDIO OUT jacks to the
TV's AUDIO IN jacks.
2
Using an S VIDEO cable, connect the DVD player's S VIDEO OUT jack
to the TV's S VIDEO IN jack (VIDEO 1 IN or VIDEO 3 IN).
Tip
If your DVD player is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of
the S VIDEO cable.
S VIDEO cable
(not supplied)
DVD player
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make
sure "Auto YC" in the
23).
Tips
• You can also use the VIDEO 2 IN jacks located on the front of the TV to connect your
DVD player.
• Use VIDEO 1/2/3 on the remote control to switch to the DVD player input.
and P jacks on your DVD player are sometimes labeled as Y, C
B R
Rear of TV
S VIDEO
S VIDEO
VIDEO
(yellow)
AUDIO-L
VIDEO
(white)
L(MONO)
AUDIO
R
AUDIO-R
(red)
(Setup) menu is set to "On" to view the S VIDEO input (see page
, P ) jacks.
B R
VIDEO IN HD/DVD IN
1 3 4
Y
P
B
P
R
L L(MONO)
AUDIO
AUDIO
R
R
and C , or Y,
B R
CENTER SPEAKER
IN
180W (6 ) MAX
AUDIO OUT
(VAR/FIX)