Connecting A Dvd Player With Component Video Connectors - Sony WEGA KLV 21SR2 Operating Instructions Manual

Installing and Connecting the TV
Connecting a DVD Player with Component Video
Connectors
16
This is the preferred hookup to use if:
• Your DVD player has component (Y, B-Y, R-Y) jacks.
Disconnect all power sources before making any connections.
1
Using a component video cable, connect the DVD player's Y, B-Y and
R-Y jacks to the Y, P
B
connections.
Note
This TV supports only the 480i and 480p signal format. If the TV receives a signal other
than 480i or 480p, "Non Supported Video Format" appears on the screen.
Tip
The Y, B-Y and R-Y jacks on your DVD player are sometimes labeled as Y, C
or Y, P and P . If so, connect the cables to the matching colors.
B R
2
Using an AUDIO cable, connect the DVD player's AUDIO OUT jacks to
the TV's AUDIO IN jacks.
Note
The Y, B-Y and R-Y jacks do not provide audio, so audio cables must be connected to
provide sound.
Rear of TV
Y
Tips
• To take advantage of the Wide Screen Modes, set the TV's aspect ratio to 16:9 on your
DVD player. For details, refer to the operating instructions supplied with your DVD player.
• Some DVD players are equipped with the three component video connectors: Y-Green, P
(C , C or B-Y) -Blue and P
B b R
and P jacks on the TV. Use the VIDEO 3 IN
R
P
B
P
R
AUDIO-L
AUDIO cable
(white)
(not supplied)
AUDIO-R
(red)
(C , C or R-Y) -Red.
R r
and C ,
B R
Component
video cable
(not supplied)
DVD player
B