Sunsound Stereo Receiver Troubleshooting - Sundance Spas 880 Series Owner's Manual

H. Scan Functions
Select any AM or FM band and press scan button (11) to listen to a few
seconds of each radio station. The display will flash and the radio will
automatically scan to the next higher station, play that station for a few
seconds, then scan to the next higher station. To stop scanning and
continue listening to the current station, press scan button a second time.
Note: The radio remains in scan mode until the scan button is pressed a
second time or one of the tune buttons is pressed.
I. Preset Scan Function
Press the auto button (16) once to enter scan mode. The next higher
preset station will be selected and be played for 3 seconds while the pre-
set number on the display flashes. If you wish to remain on this station,
press the auto button (16) a second time. Note: Preset scanning contin-
ues unless you press the auto button (16) or either preset button (P1-P6)
to cancel.
J. Local/Distance Function
Press the local button (10) to toggle between local and distant station
mode. When "LOCAL" is displayed, only the strongest stations will be
selected during seek or scan. Note: In the default mode (no LOCAL dis-
play), all usable stations will be selected during seek or scan.
K. Changing Tuner Frequency from US to Europe
Your unit is factory set to US tuning frequency steps. To switch to Europe
tuning steps, use the switch on the bottom of the unit. With the unit dis-
connected from the power source, use a screwdriver to slide the switch
to the desired position. Note: Power must be removed from the radio,
or the reset switch must be pressed before the new frequency mode is
activated.

23.4 SunSound Stereo Receiver Troubleshooting

A. Unit will not turn-on
Make sure hot tub power is turned on, then check both harness fuses on
back of unit making sure they are the proper ratings:
• Yellow memory B+ line (1A fuse); Red ACC line (10A fuse).
• With hot tub power off, use a thin rod to press the reset button
located under the front panel.
B. Fogged CDs and Lens
This condition may occur when it's cold. Wipe fogged CDs with a soft
cloth. Fogged optical components inside the unit will return to normal
operation after an hour in a heated environment.
Page 74