Sundance Spas 880 Series Owner's Manual page 60

Your Sundance hot tub is equipped with a high-efficiency MicroClean
Plus filter cartridge under the filter lid (Figures G through M, pages
22-28). Debris is filtered by the filter/circulation pump drawing water
through this cartridge 24 hours a day, 7 days a week (unless pro-
grammed otherwise.) To ensure optimum performance, replace this
cartridge every 6 months or as needed. This filter cannot be cleaned and
reused and MUST be thrown out after use.
All models include a suction cover filter (#6540-213) located
directly under the MicroClean Plus filter cartridge that prevents
debris from entering the hot tub plumbing when jets pump 1 is
running. This filter should be cleaned every 2 months.
ALWAYS TURN POWER TO THE HOT TUB OFF BEFORE
REPLACING THE MICROCLEAN PLUS FILTER CARTRIDGE!
Follow the procedures below when the filter needs replacing.
A
B
B
Loosen filter nut (A) to provide clearance,
then remove used MicroClean Plus filter
cartridge (steps B-C). Remove suction
fitting filter (D) and clean with mild liquid
soap solution and warm water, then reinstall
over suction fitting.
D
Trapped
Bubbles
Submerge new filter cartridge in spa and tilt
each end upward to remove most of the
air bubbles trapped inside the filter.
Page 54
TURN POWER TO HOT TUB OFF!
Filter
Nut
C
A
D
Air
C
Replace (throw-away) the MicroClean Plus filter
cartridge every 6 months, or as needed! DO NOT
reuse this cartridge for any reason!
E
B
1. Install new filter cartridge, then tighten filter nut until
it just touches filter face. DO NOT OVERTIGHTEN!
2. Turn power to hot tub back on.
Replace MicroClean
cartridge every 6
months, DO NOT
reuse for any reason!
Filter
Nut
A
C
Plus
A