Setting Up Your Set Top Box Receiver For The Guide Plus+ System (Analogue Mode Only) - Sony RDR-HXD1065 Operating Instructions Manual

Easy Setup - Line3 Input (Analogue
Mode only)
If you plan to connect a decoder such as
a PAY-TV/Canal Plus analogue decoder
to the LINE 3/DECODER jack, select
"Yes."
Easy Setup - Line1 Output
To output video signals, select "Video."
To output S video signals, select "S
Video."
To output RGB signals, select "RGB."
Select "Video" to enjoy the
SMARTLINK features (page 20).
• If you set "Easy Setup - Component
Out" to "On," you cannot select
"RGB."
• If you set "Easy Setup - Line3 Input" to
"Yes," you cannot select "S Video."
Easy Setup - Audio Connection
If you connected an AV amplifier
(receiver) using either a digital optical or
coaxial cord, select "Yes : DIGITAL
OUT" and set the digital output signal
(page 143).
3
Press ENTER when "Finish" appears.
"Easy Setup" is finished.
To receive GUIDE Plus+ system data
your recorder must be turned off
when not in use. If your recorder is
connected to a set top box receiver, be
sure to leave the set top box receiver
turned on. After initial setup, it may
take up to 24 hours to begin receiving
TV programme listings.
To return to the previous step
Press O RETURN.
z Hints
• If your AV amplifier (receiver) has an MPEG
audio decoder, set "MPEG" to "MPEG"
(page 143).
• If you want to run "Easy Setup" again, select
"Easy Setup" from "SETUP" in the System Menu
(page 151).
28
Setting up your set top box
receiver for the GUIDE Plus+
system (Analogue Mode only)
Follow the steps below to set up your set top
box receiver for the GUIDE Plus+ system.
Note that the OSD language, Clock, Country
and Postal Code are all set for the GUIDE
Plus+ system when Easy Setup is completed.
1
Press GUIDE
The GUIDE Plus+ system "Home
Screen" appears.
2
Select "Setup" in the Menu Bar using
M/,, and press ENTER.
The GUIDE Plus+ setup menu appears.
3
Select "Basic Setup" using M/m, and
press ENTER.
4
Select "External Receiver 1," and
press ENTER.
You can also select "External Receiver
2" or "External Receiver 3" if you have
connected additional set top box
receivers.
5
Press ENTER to select "Continue."
6
Select the set top box receiver type
using M/m, and press ENTER.
7
Select the provider using M/m, and
press ENTER.
8
Select the receiver brand using M/m,
and press ENTER.
If you select "Other providers," you can
select a receiver brand from a list of all
available brands.
If your receiver brand is not on the list,
select "???."
The receiver brand list is automatically
updated, so your receiver may be
available at a later date. Select your brand
when it becomes available. Until then,
use "???."
®
.