Sony RDR-HXD1065 Operating Instructions Manual page 155

No sound is output from the HDMI OUT
jack.
, Try the following:
and on again. Turn the connected
2
equipment off and on again.
and then connect the HDMI cord again.
, The HDMI OUT jack is connected to a DVI
device (DVI jacks do not accept audio
signals).
, The equipment connected to the HDMI
OUT jack does not conform to the audio
signal format, in this case set
"Audio(HDMI)" of "Audio Connection" to
"PCM" in the "Audio" setup (page 144).
Sound distortion occurs.
, Set "Audio ATT" in the "Audio" setup to
"On" (page 143).
Sound is noisy.
, When playing a CD with DTS sound tracks,
noise will come from the LINE 2 OUT R-
AUDIO-L jacks, LINE 1 – TV jack, or
LINE 3/DECODER jack (page 93).
The sound volume is low.
, The sound volume is low on some DVDs.
The sound volume may improve if you set
"Audio DRC" in the "Audio" setup to "TV
Mode" (page 145).
, Set "Audio ATT" in the "Audio" setup to
"Off" (page 143).
An alternate audio track cannot be
recorded or played.
, When recording from connected
equipment, set "Line Audio Input" in
OPTIONS menu to "Bilingual" (page 68).
, Multilingual tracks (main and sub) cannot
be recorded on DVD+RWs, DVD-RWs
(Video mode), DVD+Rs, or DVD-Rs
(Video mode). To record the language, set
"Bilingual Recording" of the "DVD Rec.
Settings" in the "Recording" setup to
"Main" or "Sub" before recording
(page 146). To record both the main and sub
sounds, record on DVD-RWs/DVD-Rs
(VR mode).
Turn the recorder off
1
Disconnect
3
, Any discs other than the HDD or DVD-
RWs/DVD-Rs (VR mode) cannot be used
for recording both main and sub sounds. To
record on the HDD, set "Bilingual
Recording" of the "HDD Rec. Settings" in
the "Recording" setup to "Main+Sub"
(page 145).
, If you have connected an AV amplifier to
the DIGITAL OUT (COAXIAL or
OPTICAL) jack and want to change the
audio track for HDD/DVD-RWs/DVD-Rs
(VR mode) during playback, set "Dolby
Digital" of the "Audio Connection" in the
"Audio" setup to "D-PCM" (page 143).
The sound is breaking up.
, The signal strength is low.
, Check aerial installation.
Playback
The recorder does not play any type of disc
(except HDD).
, The disc is upside down. Insert the disc with
the labelled side facing up.
, The disc is not correctly inserted.
, Moisture has condensed inside the recorder.
In this case, if the recorder is on, leave it on
(if it is off, leave it off) for about an hour
until the moisture evaporates.
, If the disc was recorded on another recorder
and was not finalised (page 44), the
recorder cannot play the disc.
The recorder does not start playback from
the beginning.
, Resume play was activated (page 91).
, You have inserted a DVD whose Title menu
or DVD menu automatically appears on the
TV screen when it is first inserted. Use the
menu to start playback.
The recorder starts playing automatically.
, The DVD VIDEO features an auto
playback function.
Playback stops automatically.
, If the DVD has an auto pause signal, the
recorder stops playback at the auto pause
signal.
155
,continued