Sony RDR-HXD1065 Operating Instructions Manual page 144

b
Note
If the HDMI OUT jack is connected to equipment
not compatible with DOLBY DIGITAL signals, the
"D-PCM" signals will be automatically output even
when you select "Dolby Digital."
• MPEG (DVD VIDEOs only)
Selects the type of MPEG audio signal.
PCM
MPEG
b
Note
If the HDMI OUT jack is connected to equipment
not compatible with MPEG audio signals, the
"PCM" signals will be automatically output even
when you select "MPEG."
• DTS (DVD VIDEOs only)
Selects whether or not to output DTS signals.
On
Off
b
Note
When HDMI output is performed to equipment not
compatible with DTS signals, the signals will not be
output regardless of the "DTS" setting.
144
Select this when the recorder
is connected to an audio
component without a built-in
MPEG decoder. If you play
MPEG audio sound tracks,
the recorder outputs stereo
signals via the DIGITAL
OUT (COAXIAL or
OPTICAL) jack.
Select this when the recorder
is connected to an audio
component with a built-in
MPEG decoder.
Select this when the recorder
is connected to an audio
component with a built-in
DTS decoder.
Select this when the recorder
is connected to an audio
component without a built-in
DTS decoder.
• 48kHz/96kHz PCM (DVD VIDEOs only)
Selects the sampling frequency of the audio
signal.
48kHz/ The audio signals of DVD
16bit
VIDEOs are converted to
48 kHz/16 bit and output.
96kHz/ All signals containing
24bit
96 kHz/24 bit are output
without conversion.
However, the signals are
output at 48 kHz/16 bit if
copyright-protected signals
are contained.
b
Notes
• "48kHz/96kHz PCM" setting has no effect when
audio signals are output from the LINE 2 OUT
(R-AUDIO-L) jacks or LINE 1 – TV/LINE 3/
DECODER jack. If the sampling frequency is
96 kHz, signals are simply converted to analogue
signals and output.
• If the HDMI OUT jack is connected to equipment
not compatible with 96 kHz signals, 48 kHz PCM
will be automatically output even when you select
"96kHz/24bit."
• Audio(HDMI)
Selects the type of audio signal output from
the HDMI OUT jack.
Auto
Normally select this position.
Outputs the optimum audio
signal that can be received by
the TV based on the "Digital
Out" setting (page 143).
PCM Converts Dolby Digital or
96 kHz PCM signals to
48 kHz/16 bit PCM.
b
Notes
• A loud noise (or no sound) will be output if you
connect the recorder to a TV that is not
compatible with DOLBY DIGITAL/DTS signals
and "Auto" is selected. In this case, select
"PCM."
• Set "Digital Out" to "On" when outputting
compressed audio signals to an HDMI
compatible TV.