Audio Output - Sony 3-293-880-11(1) Operating Instructions Manual

b
Notes
• When picture noise appears after you change the
"Screen Resolution" setting, hold down x (stop)
on the recorder, and press Z (open/close) on the
recorder.
• When "Colour" is set to "YCbCr 4:2:2" in the
"HDMI Output" setup, you cannot select "720 x
576i" (or "720 x 480i").
4:3 Video Output
This setting is effective only when you set
"TV Type" to "16:9" in the "Playback"
setup.
Adjust this setting to watch 4:3 aspect ratio
signals. If you can change the aspect ratio on
your TV, change the setting on your TV, not
this recorder.
Note that this setting is effective only for
HDMI connection.
Full
Normal
16:9 aspect ratio TV
114
Select this when you can
change the aspect ratio on
your TV.
Select this when you
cannot change the aspect
ratio on your TV. Shows a
4:3 size video with the
aspect ratio as it is.
Colour
Selects the method of outputting video
signals for the HDMI jack.
RGB (0-255)
Outputs RGB (0-255)
signals. Select this when
connecting to an RGB (0-
255) device.
RGB (16-235) Outputs RGB (16-235)
signals. Select this if
colours appear overly
rich and the black
appears too deep.
YCbCr 4:2:2 Outputs 10-bit YCbCr
4:2:2 component signals.
YCbCr 4:4:4 Outputs 8-bit YCbCr
4:4:4 component signals.
b
Notes
• Some settings may not be available depending
on the connected device.
• When a DVI device is connected, you cannot
select "YCbCr 4:2:2" or "YCbCr 4:4:4."
• When "Screen Resolution" is set to "720 x 576i"
(or "720 x 480i") in the "HDMI Output" setup,
you cannot select "YCbCr 4:2:2."

Audio Output

Selects the type of audio signal output from
the HDMI OUT jack.
Auto
Outputs Dolby Digital,
MPEG and DTS audio
signals as a bitstream
signal. Normally select
this position.
PCM Converts all audio
signals except for DTS
signals to PCM.
Bitstream Select this if the
Priority
connected device is
compatible with
bitstream audio.