Panasonic S-200PE2E5 Technical Data & Service Manual page 183

2. Wireless Remote Controller
2. Installing the Receiver
1
Remove the bottom case.
2
Mount to the wall.
E
Preparation: Make 2 holes for screws using a driver.
(3)
Mount the top case.
 Align the claws of
the top case and
then align the claws
of the bottom case.
Cut here with a
nipper and remove
the burr with
f a . e l i
Claw (2 places)
Wood screw (supplied)
Connect the remote controller wiring.
(2)
 Arrange the wires along the groove of the case.
Top case
(Back side)
Bottom case (Back side)
Insert the driver
and slightly turn.
Flat-blade
Bottom
screwdriver
case
x p o s e d y t p e
(1)
Mount the bottom case
to the wall.
W l l a o t x i f h t e
receiver
Claw
Hole for screw
Clamper
(supplied)
Pass through
the hole.
Remove the coating. Approx. 6 mm
Remove the sheath. Approx. 150 mm
Make sure the wiring connection
is in the correct direction.
Attention
Mounting the bottom case
 Tighten the screws securely until the screw
heads touch the bottom case.
(Otherwise, loose screw heads may hit the
PCB and cause malfunction when mounting
the top case.)
 Do not over-tighten the screws.
(The bottom case may be deformed, resulting
in fall of the unit.)
Connecting the remote controller wiring
 Arrange the wires as shown in the illustration for (2) in step 2,
avoiding unnecessary wires being stored in the case. (Caught
wires may destroy the PCB.)
 Avoid wires touching parts on the PCB.
(Caught wires may destroy the PCB.)
E m b e
Preparation: Make 2 holes for screws using a driver.
(3) (1)
Mount the top case.
 Align the claws of
the top case and
then align the claws
of the bottom case.
Avoid the wire
being caught.
Claw (2 places)
Wood screw (supplied)
Connect the remote controller wiring.
(2)
Top case
(Back side)
Bottom case (Back side)
8-17
Control of 2WAY SYSTEM
d d e d y t p e
Mount the bottom case to
the wall.
 Pass the wire through the hole
in the centre of the bottom case.
Claw
Hole for screw
Terminal board
Remove the coating.
Approx. 6 mm
Make sure the wiring connection
is in the correct direction.
8