Panasonic S-200PE2E5 Technical Data & Service Manual page 176

2. Wireless Remote Controller
Matching up Addresses
Setting Remote Controller Addresses
1. If you press
2. While holding
Set it to the receiver address switch of the indoor unit you wish to operate.
3. When you release
When you do this, if it corresponds to the receiver's address setting, the buzzer sounds.
Address
Display on the
Remote Controller
CZ-RWSC3
Position of
the Receiver's
Address Switch
NOTE
• Please do not hold the [Emergency Operation]
blinking one after another.
• Make sure to operate while the indoor unit is stopped.
• The address of indoor unit is set to "ALL" at the time of the shipment.
8
and at the same time, "
down, every time you press
, the address that was displayed is set.
The position of the
receiver's address
switch does not
matter.
" will blink.
, it cycles from ALL
button of the indoor unit down while the indoor unit's display lamps are
8-10
Control of 2WAY SYSTEM
1 2 3... 6 ALL.
For 1, 2 and 3, set the switch on the
left and for 4, 5 and 6, to the right.