Panasonic S-200PE2E5 Technical Data & Service Manual page 170

RECEIVER
1. Receiver
2. Emergency
operation
button
3. OPERATION lamp
4. Timer lamp
5. STANDBY lamp
6. FILTER lamp
NOTE
• If non-cooling/heating free type is being used, it will beep twice and the operating lamp will light up
on the display; if the timer and standby lamps blink alternately, a confl ict between the heating and
cooling exists, so the uncannot operate in the desired mode. (On models that do not have an Auto
function, even if Auto is selected, it works in the same way.)
• When the local operation is disabled by centralized control or similar cause,and if the Start/Stop
Mode or Temperature setting button
change will not be made.
8
Receives the signal sent from the
remote controller.
Indicator lamps
When an error occurs, one of the
lamps flashes. When an indicator
lamp is flashing, refer to
"8-13. Before Requesting Service".
Lights up when the unit is operating.
Lights up when the timer is set.
• The lamp in the HEAT mode
lights up at the following times:
during the startup, during the
thermostat operation, and during
the defrosting.
• The lamp flashes when an error
occurs.
This lamp is for notifying you when
the filter needs to be cleaned.
1
2
3
4
5
6
is pressed, the unit will beep five times and the
8-4
CZ-RWSC3
,