Rear Wheel Circuit Filling Instructions; [Integral Abs]; Reading Fault Code Memory With Bmw Moditec; Performing A Bleed Test With Bmw Moditec - BMW R 1150 R Maintenance Manual

Rear wheel circuit filling instructions

34 1 536
•
Top up fluid in rear wheel circuit reservoir to
"MAX".
•
Screw the reset device, BMW No. 34 1 531, to
the adapter, BMW No. 34 1 536.
e
Important:
The piston in the base of the wheel circuit reservoir
must always be covered by the fluid, as otherwise air
can be drawn into the brake system.
Bleed the system again if this happens.
•
Switch on the ignition.
L
Note:
Always wait for the BMW Integral ABS to complete
its self-diagnosis after the ignition is switched on.
Do not operate the brake lever until self-diagnosis is
complete.
•
Press the foot brake lever until the rear brake cal-
iper pistons rest on the
reset device, BMW No. 34 1 531, and the
adapter, BMW No. 34 1 536.
•
Switch off the ignition.
MAX
MIN
•
Top up the fluid in the wheel circuit reservoir until
one of the three protrusions in the filler neck just
touches the surface of the fluid (arrow).
•
Remove the reset device, BMW No. 34 1 531,
with adapter, BMW No. 34 1 536.
34.24
d
Warning:
The wheel circuit reservoir may not overflow while
the brake pads/brake calipers are being fitted.
•
If necessary, carefully press back the pistons un-
til the brake disc just fits between the brake
pads.
•
Fit the brake pads and brake caliper at the rear.
•
Hand-tighten the rear wheel circuit reservoir cap.
•
Perform a function check on the brake system
with the ignition switched on.
34 1 531
•
Once all the work on the brake system has been
completed, read the fault code memory and per-
form a bleed test using BMW MoDiTeC.
R28000170
•
Remove fuel tank (
•
Remove rear panel.
•
Install front/rear seat.
Brake fluid ...................................................DOT 4
X
Tightening torque:
Rear brake caliper bleed screw ...................... 7 Nm
Brake caliper to rear wheel drive .................. 40 Nm

[Integral ABS]

34 00
Reading fault code memory with
BMW MoDiTeC
•
Remove front/rear seat.
•
Connect the BMW MoDiTeC to the diagnostic
connector.
•
Read out the fault memory.
•
Clear fault code memory if necessary, or perform
all requisite repair work.
[Integral ABS]
34 00
Performing a bleed test with
BMW MoDiTeC
•
Remove front/rear seat.
•
Connect the BMW MoDiTeC to the diagnostic
connector.
d
Warning:
Avoid rapid and forceful pumping of the brakes
when performing maintenance and repair work on
the BMW Integral ABS.
•
Perform bleed test.
•
Perform all requisite repair work.
R28340090
16.5).
a