Mercedes-Benz 260 E 124 1988 Owner's Manual page 83

Replacing bulbs:
Bulb for turn signal, parking, side
marker and standing lamp
(21/5 W/32/3 cp):
Compress retaining clip (4) and
remove housing towards the front.
Turn bulb socket (7) with bulb coun­
terclockwise and pull out. Push bulb
into socket, turn counterclockwise and
remove.
Bulb for high and low beam
(Halogen type 9004):
Compress cover (5) at the top and
remove upwards. Pull off electrical
connector ( ). Turn clamping ring (9)
8
counterclockwise and pull out bulb
together with clamping ring. Remove
bulb.
Insert new bulb (flat side facing up),
mount clamping ring (9) (with tab fac­
ing down) and turn clockwise. Push
electrical connector on securely.
Fog lamp bulb (Halogen type H3):
Compress the retaining clip of the
cover ( ) at the top while removing it
6
upwards. Pull off electrical connector
(11). Disengage retaining clip and re­
move bulb (10). When replacing cover
( ), make sure it clicks into place.
6
Taillamp Assemblies
1 Turn signal lamp (21 W/32 cp bulb)
2 Backup lamp (21 W/32 cp bulb)
3 Side marker lamp (10 W
4 Stop lamp (21 W/32 cp bulb)
5 Tail, parking and standing lamp
(10 W cp bulb)
/ 6
Turn the taillamp bulb carrier lock in
the trunk all the way to the left and
remove bulb carrier. To replace a
lamp, push lamp in, turn to the left and
remove.
cp bulb)
/ 6
81