Direct frequency tuning
In order to select a station with a known frequency, select the wave band (AM or
FM), press the function control button
pressing the corresponding pushbuttons.
Example:
Press any button marked
Press the function control button
Enter frequency by pressing
When tuning a frequency directly, the pushbutton number is not displayed on the
panel. The wave band is indicated by showing " MHz" for FM or " kHz" for AM.
Note:
All AM stations have allocated frequencies ending with a " 0 " .
All FM stations have allocated frequencies ending with an odd-numbered digit
following the decimal point.
Broadcasters sometimes may not give their exact frequency but the next closest
whole number.
US radio frequency ranges:
AM 5 4 0 -1 6 0 0 kHz
FM 8 8 .1 -1 0 7 .9 MHz
56
and then enter the frequency by
AM 1050 kHz
FM 98.5 MHz
through QJJ
D
D
rm m g nn
jfEl 1 1 0 3 EI3 fj|^
Manual tuning
(For fine tuning a station or for manual
tuning)
After selecting the desired AM or FM
wave band, press the manual tuning
D .
button
through
quency) or
frequency).
The frequency will increase or
decrease respectively in increments
of 0.1 MHz for FM or 1.0 kHz for AM.
Release the button when the desired
station is tuned in.
Please note: It is recommended that
manual tuning operations be per
formed by the driver only while the ve
hicle is not moving. The driver should
use the automatic station seeker/scan
ner or pushbutton tuning when the ve
hicle is in motion.
Pushbutton tuning
Six FM stations and four AM stations
can be stored in memory and recalled
by pressingthe appropriate buttons
marked
m
through
(decreasing station fre
(increasing station
through Q J J for FM or
for AM stations.