Setting Data; General Sd Bits; Axis-Specific Bits - Siemens SINUMERIK 810M Operating And Programming Manual

09.91
7.4

Setting data

7.4.1

General SD bits

SD 5000 Bit 0,1,2: As from standard UMS 03 the user interface and the cycles have been
completely revised. The cycles have new and expanded functions. For
these functions, new or modified cycle parameter assignments (R
parameters) are required.
To guarantee part program compatibility the new functions are activated
with set SD bits.
The SD bits must be zero (compatibility mode) on programs which were
developed with older software versions (e.g. 810 A1 SW06).
On programs developed with the user interface from UMS03 the SD bits
must be set accordingly.
Turning cycles
L95/L93/L98
SD 5000
Bit
M
T
Bit = 1 cycle function expansion from UMS from version 03 can be used
Bit = 0 cycle function as UMS version less than or equal to 02 (compatible mode).
7.4.2

Axis-specific bits

SD
No.
7 6
560*
In SD 560*, bit 2 the axis in question is enabled for scale modification.
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810M, GA3 (BN)
Drilling patterns
Milling patterns
L903/L930
2 1
0 1
1 0
Bit No.
5 4 3
6ZB5 410-0EQ02
7 Interfacing to the Machine
7.4 Setting data
Drilling cycles
L81 - L89
0
1
1
2 1
Enable
scale
modification
0
7-11