Definition Of The Initial Setting Of The G Groups - Siemens SINUMERIK 810M Operating And Programming Manual

09.91
7.3.4

Definition of the initial setting of the G groups

Previously the initial settings for the G groups 0/2/3/5/7/9/10/11 and 13 were defined
permanently (For G group allocation see Section 12).
Now you can define the initial setting of
G groups 0/2/5/7 and 11
channel-specifically. Simply enter the number of the G function you want to be the
initial setting in the channel data.
Exception:
The initial setting G70/G71 is still entered in machine data 5002, bit 4.
Sequence of operation
Sequence of operation
DIAG-
NOSIS
CHANNEL
DATA
NC MD
A display with the channel-specific machine data MD 1000 to 1016 appears. Use the "page
down" key to page through the display until the machine data up to 1199 appear. Now you
can enter the initial settings of the above G groups directly into MD 108* to 118* (2nd
steps). Four input fields are available to you. In the first two (from left to right) of each you
define the channel-specific (1st and 2nd channel) initial setting of the G group assigned to
the machine data. Inputs in other input fields cause the alarm message "General data
error". The allocation of NC MDs to G groups or G functions are to be found in the
overview on the next page.
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810M, GA3 (BN)
7.3.4 Definition of the initial setting of the G groups
Press the "DIAGNOSIS" softkey.
Extend the menu displayed with the ETC key and press
the "NC MD" softkey. Extend the softkey menu again
and press the "CHANNEL DATA" softkey again.
6ZB5 410-0EQ02
7 Interfacing to the Machine
7-9