Additional Information; Troubleshooting - Sony DVP-NS305 Operating Instructions Manual

Additional Information

Troubleshooting

If you experience any of the following
difficulties while using the player, use this
troubleshooting guide to help remedy the
problem before requesting repairs. Should
any problem persist, consult your nearest
Sony dealer.
Power
The power is not turned on.
, Check that the power cord is connected
securely.
Picture
There is no picture/picture noise appears.
, Re-connect the connecting cord securely.
, The connecting cords are damaged.
, Check the connection to your TV (page 18)
and switch the input selector on your TV
so that the signal from the player appears
on the TV screen.
, The disc is dirty or flawed.
, If the picture output from your player goes
through your VCR to get to your TV or if
you are connected to a combination TV/
VIDEO player, the copy-protection signal
applied to some DVD programmes could
affect picture quality. If you still
experience problems even when you
connect your player directly to your TV,
please try connecting your player to your
TV's S VIDEO input (page 18).
, If the colour system of your player does
not match with that of your TV, change the
colour system of the player. For details, see
page 16. (You cannot change the colour
system of the DVD disc itself.)
Even though you set the aspect ratio in
"TV TYPE" of "SCREEN SETUP," the
picture does not fill the screen.
, The aspect ratio of the disc is fixed on your
DVD.
Sound
There is no sound.
, Re-connect the connecting cord securely.
, The connecting cord is damaged.
, The player is connected to the wrong input
jack on the amplifier (receiver) (page 22,
23, 24).
, The amplifier (receiver) input is not
correctly set.
, The player is in pause mode or in Slow-
motion Play mode.
, The player is in fast forward or fast reverse
mode.
, If the audio signal does not come through
the DIGITAL OUT (OPTICAL or
COAXIAL) jack, check the audio settings
(page 63).
, While playing a Super VCD on which the
audio track 2 is not recorded, no sound will
come out when you select "2:STEREO,"
"2:1/L," or "2:2/R."
Sound is noisy.
, When playing a CD with DTS sound
tracks, noise will come from the LINE
OUT L/R (AUDIO) jacks or DIGITAL
OUT (OPTICAL or COAXIAL) jack (page
28).
Sound distortion occurs.
, Set "AUDIO ATT" in "AUDIO SETUP" to
"ON" (page 62).
The sound volume is low.
, The sound volume is low on some DVDs.
The sound volume may improve if you set
"AUDIO DRC" to "TV MODE" (page 62).
, Set "AUDIO ATT" in "AUDIO SETUP" to
"OFF" (page 62).
Operation
The remote does not function.
, There are obstacles between the remote
and the player.
, The distance between the remote and the
player is too far.
, The remote is not pointed at the remote
sensor on the player.
, The batteries in the remote are weak.
, continued 65