Settings For The Sound (Audio Setup) - Sony DVP-CX995V Operating Instructions (DVP-CX995V CD/DVD Player) Operating Instructions Manual

Settings for the Sound
(AUDIO SETUP)
"AUDIO SETUP" allows you to set the sound
according to the playback and connection
conditions.
Select "AUDIO SETUP" in the Setup
Display. To use the display, see "Using the
Setup Display" (page 76).
The default settings are underlined.
AUDIO SETUP
AUDIO ATT:
AUDIO FILTER:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
DTS:
48kHz/96kHz PCM:
AUDIO(HDMI):
◆ AUDIO ATT (attenuation)
If the playback sound is distorted, set this
item to "ON." The player reduces the audio
output level.
This function affects the output of the
following jacks:
– LINE OUT AUDIO L/R 1/2 jacks
– 5.1CH OUTPUT jacks
OFF Normally, select this position.
ON
Select this when the playback sound
from the speakers is distorted.
◆ AUDIO FILTER (except Super Audio CD)
Selects a digital filter to reduce noise above
22.05 kHz (Sampling frequency (Fs) of the
audio source is 44.1 kHz), 24 kHz (Fs is 48
kHz), or 48 kHz (Fs is above 96 kHz).
SHARP
Provides a wide frequency
range and spatial feeling.
SLOW
Provides smooth and warm
sound.
Note
There may be little effect by changing the digital
filter depending on the disc or playback
environment.
◆ DOWNMIX (DVD VIDEO/DVD-RW only)
Switches the method for mixing down to 2
channels when you play a DVD which has
rear sound elements (channels) or is recorded
in Dolby Digital format. For details on the
rear signal components, see "Displaying the
disc's audio information" (page 59). This
function affects the output of the following
jacks:
– LINE OUT AUDIO L/R 1/2 jacks
– DIGITAL OUT (COAXIAL or OPTICAL)/
DOLBY
SUR-
OFF
ROUND
SHARP
DOLBY SURROUND
ON
D-PCM
NORMAL
D-PCM
48kHz/16bit
AUTO
◆ DIGITAL OUT (except Super Audio CD)
Selects if audio signals are output via the
DIGITAL OUT (COAXIAL or OPTICAL)/
HDMI OUT jack.
ON
OFF
• Super Audio CD audio signals are not output from
• If you are using the HDMI OUT jack, make sure
HDMI OUT jack when "DOLBY
DIGITAL" is set to "D-PCM" (page 82).
Normally select this position.
Multi-channel audio signals are
output to two channels for
enjoying surround sounds.
Multi-channel audio signals are
downmixed to two channels for
use with your stereo.
Normally select this position. When
you select "ON," see "To set the digital
output signal" for further settings.
The influence of the digital circuit
upon the analog circuit is minimal.
If the signal is encrypted for copyright
protection purposes, the signal is only
output as 48 kHz/16 bit PCM.
Notes
the DIGITAL OUT (COAXIAL or OPTICAL)/
HDMI OUT jack.
that "DIGITAL OUT" is set to "ON."
81
c continued