Sony Cyber-Shot DSC-P32 Operating Instructions Manual page 92

Symptom
The power turns off
suddenly.
Shooting still images / movies
Symptom
The LCD screen is not
turned on even when the
power is turned on.
The subject is not visible
on the LCD screen.
The image is out of focus. • The subject is too close.
Unable to zoom (DSC-P52/
P72 only).
Smart zoom does not
function.
The image is too dark.
92
Cause
• If you do not operate the camera for about 90
seconds while the power is on, the camera turns
off automatically to prevent wearing down the
battery (when [Power Save] is [Off], after three
minutes.) (page 17).
• The batteries are discharged.
Cause
• The power was turned off with the LCD screen
turned off the last time you used the camera.
• The mode selector is not set to
While shooting still images,
•
set to or .
• You set the focus preset distance.
• You cannot zoom while shooting a movie
(MPEG movie).
• You cannot use smart zoom while shooting a
movie (MPEG movie).
• The LCD screen is turned off.
image size
• The is set to [3.1M] or [2.8M (3:2)].
• [Smart Zoom] is set to [Off] in the SET UP
settings (DSC-P52/P72 only).
• You are shooting a subject with a light source
behind the subject.
• The brightness of the LCD screen is too low.
Solution
p Turn on the camera again (page 20).
p Install charged batteries (page 14).
Solution
p Turn on the LCD screen (page 34).
p Set the mode selector to
or .
p Set the macro recording mode (DSC-P72 only). Make sure to
place the lens farther away from the subject than the shortest
shooting distance when shooting (page 30).
p Cancel the mode (page 58).
(Camera) is
p Set to the auto focus mode (page 49).
—
—
p Turn on the LCD screen (page 34).
p Set image size
(page 29).
p Set [Smart Zoom] to [On] (page 106).
p Adjust the exposure (page 50).
p Adjust the brightness of the LCD screen (page 107).
or (pages 26, 72).
to other settings except [3.1M] and [2.8M (3:2)]