Sony digital still camera operating instructions (124 pages)
Summary of Contents for Sony DSC-P72
Page 1
DSC-P72 SERVICE MANUAL LEVEL US Model Ver 1.1 2003. 03 Canadian Model Revision History Revision History AEP Model UK Model E Model Australian Model Hong Kong Model Korea Model Chinese Model Tourist Model Japanese Model Link Link SPECIFICATIONS BLOCK DIAGRAMS...
Page 2
CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS REMPLACER CES COMPOSANTS QUE PAR DES PIÈSES SONY APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU PUBLISHED BY SONY.
Page 3
DSC-P72 SAFETY CHECK-OUT After correcting the original service problem, perform the following safety checks before releasing the set to the customer. Unleaded solder Check the area of your repair for unsoldered or poorly-soldered Boards requiring use of unleaded solder are printed with the lead- connections.
The electric shock is caused by the charged voltage which is kept without discharging when the main power of the DSC-P72 is simply turned off. Therefore, the remaining voltage must be discharged as described below.
Page 6
• The type of memory stick that cannot be Replace the memory stick. used by this machine, is inserted. C:13:01 MS ERROR Format the memory stick with the DSC-P72. • Data is damaged. • Unformatted memory stick is inserted. Flash LED Checking of flash unit or replacement of...
DSC-P72 SECTION 2 COVER COVER HELP HELP DISASSEMBLY The following flow chart shows the disassembly procedure. DISASSEMBLY SY-85 board service position DISASSEMBLY HELP Discharging the Capacitor DISASSEMBLY DISASSEMBLY DISASSEMBLY DISASSEMBLY DISASSEMBLY HELP DISASSEMBLY HELP PROCEDURE OF REMOVING SY-85 BOARD (SERVICE POSITION) 1 2-1.
DSC-P72 NOTE: Follow the disassembly procedure in the numerical order given. 2-1. CABINET (R) BLOCK ASSEMBLY Caution Attach the Tape (Y) as shown in the illustration. 6 Claw SY-85 board Tape (Y) 7 Claw Control switch block (SW-391)(39P) Tape (Y) 1 Screw (M2 ×...
DSC-P72 2-2. BLOCK LIGHT GUIDE PLATE, LCD MODULE, CONTROL SWITCH BLOCK (SW-391), LITHIUM BATTERY Lithium battery Caution Caution When installing it, Danger of explosion if batteryis incorrectly replaced. align the switch position Replace only with the same or equivalent type.
DSC-P72 2-3. MAIN BLOCK ASSEMBLY Caution The power supply capacitor of the Flash unit is charged to the voltage as high as 300 V at a maximum. The high voltage is not discharged even after the main power of the machine is simply turned off and the charged potential still remains.
DSC-P72 2-8. SY-85 BOARD Caution When removing the harness, be sure to pull the harness up at the right angle with the board while pressing down the connector on the circuit board. Connector 2 Battery holder (with terminal) (4P) 1 Four screws(M2 × 3)
Page 14
DSC-P72 [SERVICE POSITION (SY-85 BOARD)] Memory stick connector AC power AC IN Cabinet (rear) block assembly adaptor JK block (39P) (JK-252) (10P) DC jack CN702 (39P) CN701 CN706 CN201 CN704 (12P) CN705 (10P) ST-82 board (27P) Unit parts(UA-002) (10P) SY-85 board...
DSC-P72 2-10.CIRCUIT BOARDS LOCATION SY-085 ST-082 Board Name Function SY-085 CCD IMAGER, CAMERA A/D CONVERTER, LENS DRIVE, CAMERA DSP, VIDEO AMP, SH DSP, CLK GEN., FRONT CONTROL, AUDIO I/O, LCD DRIVE, TIMING GEN., DC IN, DC-DC CONVERTER., CONNECTOR ST-082 FLASH DRIVE...
DSC-P72 2-11.FLEXIBLE BOARDS LOCATION The flexible boards contained in the video lens are not shown. CONTROL SWITCH BLOCK (SW-391) CONTROL SWITCH BLOCK (RL-059) UNIT PARTS (UA-002) FP-643 JK BLOCK (JK-252) 2-10E...
Page 17
DSC-P72 17/Feb/2003. Update HELP Sheet attachment positions and procedures of processing the flexible boards/harnesses are shown. MAIN BLOCK SECTION SY-85 board SY-85 board Caution A (280) label Caution B (280) label SY-85 board Tape (Y) Busteraid 280 SY-85 board HELP...
DSC-P72 COVER COVER 3. BLOCK DIAGRAMS Link Link OVERALL BLOCK DIAGRAM FRONT/LCD BLOCK DIAGRAM OVERALL BLOCK DIAGRAM FRONT/LCD BLOCK DIAGRAM CAMERA BLOCK DIAGRAM CAMERA BLOCK DIAGRAM POWER BLOCK DIAGRAM POWER BLOCK DIAGRAM...
Page 19
DSC-P72 SECTION 3 3. BLOCK DIAGRAMS 3. BLOCK DIAGRAMS COVER COVER BLOCK DIAGRAMS 3-1. OVERALL BLOCK DIAGRAM ( ) : Number in parenthesis ( ) indicates the division number of schematic diagram where the component is located. SY-85 BOARD SW-391 (1/2)
Page 20
DSC-P72 3. BLOCK DIAGRAMS 3. BLOCK DIAGRAMS COVER COVER ( ) : Number in parenthesis ( ) indicates the division number of schematic diagram where the component is located. 3-2. CAMERA BLOCK DIAGRAM SY-85 BOARD (1/2) IC301 (3/10) (4/10) (4/10)
Page 21
DSC-P72 3. BLOCK DIAGRAMS 3. BLOCK DIAGRAMS COVER COVER 3-3. FRONT/LCD BLOCK DIAGRAM ( ) : Number in parenthesis ( ) indicates the division number of schematic diagram where the component is located. SY-85 BOARD (2/2) SW-391 (3/3) PANEL UNIT...
Page 22
DSC-P72 3. BLOCK DIAGRAMS 3. BLOCK DIAGRAMS COVER COVER ( ) : Number in parenthesis ( ) indicates the division number of schematic diagram where the component is located. 3-4. POWER BLOCK DIAGRAM SY-85 BOARD CN001 F007 BATT UINREG BATT UNREG...
DSC-P72 4-2. SCHEMATIC DIAGRAMS 4-2. SCHEMATIC DIAGRAMS COVER COVER THIS NOTE IS COMMON FOR SCHEMATIC DIAGRAMS (In addition to this, the necessary note is printed in each block) (For schematic diagrams) 1. Connection • All capacitors are in µF unless otherwise noted. pF : µ...
Page 27
DSC-P72 4-2. SCHEMATIC DIAGRAMS 4-2. SCHEMATIC DIAGRAMS ST-82 PRINTED WIRING BOARD ST-82 PRINTED WIRING BOARD COVER COVER 4-2. SCHEMATIC DIAGRAMS For Schematic Diagram • Refer to page 4-37 for printed wiring board of ST-82 board. ST-82 BOARD NO MARK:REC/PB MODE...
Page 28
DSC-P72 4-2. SCHEMATIC DIAGRAMS 4-2. SCHEMATIC DIAGRAMS JK BLOCK FLEXIBLE BOARD JK BLOCK FLEXIBLE BOARD COVER COVER For Schematic Diagram • Refer to page 4-43 for printed wiring board. JK BLOCK (JK-252) MS_VSS MS_VSS MS_VCC MS_VCC MS_VCC MS_SCLK MS_SCLK N.C.
Page 29
DSC-P72 4-2. SCHEMATIC DIAGRAMS 4-2. SCHEMATIC DIAGRAMS 4-3. PRINTED WIRING BOARDS 4-3. PRINTED WIRING BOARDS COVER COVER • CONTROL SWITCH BLOCK (SW-391) is replaced as a block. So that this PRINTED WIRING BOARD is omitted. CONTROL SWITCH BLOCK (SW-391) LCD,CONTROL(SW BLOCK)
Page 30
DSC-P72 4-2. SCHEMATIC DIAGRAMS 4-2. SCHEMATIC DIAGRAMS 4-3. PRINTED WIRING BOARDS 4-3. PRINTED WIRING BOARDS COVER COVER • CONTROL SWITCH BLOCK (RL-059) is replaced as a block. So that this PRINTED WIRING BOARD is omitted. • UA-002 BOARD is replaced as a block. So that this PRINTED WIRING BOARD is omitted.
DSC-P72 COVER COVER 4-3. PRINTED WIRING BOARDS Link Link ST-82 BOARD JK BLOCK (JK-252) ST-82 BOARD JK BLOCK (JK-252) COMMON NOTE FOR PRINTED WIRING BOARDS COMMON NOTE FOR PRINTED WIRING BOARDS MOUNTED PARTS LOCATION CIRCUIT BOARDS LOCATION CIRCUIT BOARDS LOCATION...
Page 32
DSC-P72 4-3. PRINTED WIRING BOARDS 4-3. PRINTED WIRING BOARDS COVER COVER THIS NOTE IS COMMON FOR WIRING BOARDS (In addition to this, the necessary note is printed in each block) (For printed wiring boards) • Chip parts. • : Uses unleaded solder.
DSC-P72 4-3. PRINTED WIRING BOARDS 4-3. PRINTED WIRING BOARDS COVER COVER 4-5. MOUNTED PARTS LOCATION no mark : side A * mark : side B ST-82 BOARD * C503 * C504 * C505 Mounted parts location of the SY-85 board...
Page 36
DSC-P72 COVER COVER NOTE NOTE 5. REPAIR PARTS LIST NOTE: Characters A to Z of the electrical parts list indicate location of exploded views in which the desired part is shown. EXPLODED VIEWS EXPLODED VIEWS Link Link CABINET (FRONT) SECTION...
Page 37
DSC-P72 5. REPAIR PARTS LIST 5. REPAIR PARTS LIST COVER COVER NOTE: • -XX, -X mean standardized parts, so they may have some differences from When indicating parts by reference number, the original one. please include the board name. •...
Page 38
DSC-P72 5. REPAIR PARTS LIST 5. REPAIR PARTS LIST COVER COVER 5-1. EXPLODED VIEWS 5-1-1. CABINET (FRONT) SECTION ns : not supplied Cabinet (rear) block assembly (See page 5-5) Main block assembly (See page 5-4) Ref. No. Part No. Description Ref.
Page 39
DSC-P72 5. REPAIR PARTS LIST 5. REPAIR PARTS LIST COVER COVER 5-1-2. MAIN BLOCK SECTION ns : not supplied J101 CN101 J102 BT901 IC351 (Note) Be sure to read “Precautions upon replacing CCD imager” on page 4-7 when changing the CCD imager.
Page 40
DSC-P72 5. REPAIR PARTS LIST 5. REPAIR PARTS LIST COVER COVER 5-1-3. CABINET (REAR) BLOCK SECTION ns : not supplied LCD901 BT100 ND901 : For the installation position of BT100 (Lithium battery), refer to page 2-3 CAUTION : Danger of explosion if battery is incorrectly replaced.
Page 42
DSC-P72 Checking supplied accessories. Make sure that the following accessories are supplied with your camcorder. Power cord (1)(AUS model) Battery charger (BC-CS2)(1) Connection cord Hand strap (1) 0 1-696-819-11 (US,CND,JE,J model) (AV Cable 1.5m)(1) 3-070-841-01 0 1-477-814-11 Power cord (1)(AEP,E model)
Page 44
DSC-P72 LEVEL US Model SERVICE MANUAL Canadian Model AEP Model Ver 1.1 2003. 03 UK Model E Model Australian Model Hong Kong Model Brazilian Model Korea Model Chinese Model Tourist Model Japanese Model SUPPLEMENT-1 File this supplement with the Service Manual.
Page 45
DSC-P72 (Page 2-3) SECTION 2 DISASSEMBLY 2-2. BLOCK LIGHT GUIDE PLATE, LCD MODULE, CONTROL SWITCH BLOCK (SW-391), LITHIUM BATTERY Lithium battery Caution Caution When installing it, Danger of explosion if batteryis incorrectly replaced. align the switch position Replace only with the same or equivalent type.
Page 46
DSC-P72 (Page 5-5) SECTION 5 REPAIR PARTS LIST 5-1. EXPLODED VIEWS 5-1-3. CABINET (REAR) BLOCK SECTION ns : not supplied LCD901 BT100 ND901 : For the installation position of BT100 (Lithium battery), refer to page 2-3 CAUTION : Danger of explosion if battery is incorrectly replaced.
Page 48
Reverse 987622932.pdf Revision History S.M. Rev. Ver. Date History Contents issued 2003.02 Official Release — — 2003.03 Supplement-1 Addition of the Brazilian Model.