Carrier ComfortVu TB-24-HM Installation And Operation Manual page 14

Weekly program (cont.)
Programming procedure
The detailed programming procedure is described in the next sections. Make sure to follow the right

programming procedure, suitable for the program type and features selected by Technician
Settings.
Press the [C/F - Prog] button to enter and proceed through the steps of the real time clock and

programming procedure.
Use the [+] and [-] buttons to select or change value of a flashing icon.

We recommend that you select programming values prior to the actual programming.

Exit the programming procedure
At anytime during the programming procedure, press the [On/Off] button to exit and return to normal
display - any changed values will be saved.
Adjusting the time and day of the week
The BACnet Thermostat will respond to a BACnet time sync, but you can manually set it using the
following instructions.
1. Press and hold the [C/F - Prog] button. The word "Clock" will appear on display, and
the HOURS will flash.
Hours
2. Use the [+] and [-] buttons to adjust the hours.
Minutes
3. Press the [C/F - Prog] button again. The MINUTES will flash.
4. Use the [+] and [-] buttons to adjust the hours.
Days
5. Press the [C/F - Prog] button again. The DAYS will flash.
6. Use the [+] and [-] buttons to select the day.
7. If Technician Setting P107 is not set to "00" (program is enabled), press the [C/F – Prog] button
to enter programming procedure. Make sure to follow the right programming procedure, suitable
for the program type and features selected by Technician Settings.
Section C – "EU Type"
Section D – "US Type"
Otherwise, press the [C/F - Prog] button to return to normal display.
- 14 -