Using The Self-Timer; Using The Flash - Sony Cyber-shot DSC-F828 Operating Instructions Manual

Using the self-timer

80
min 101
8M
98
MAF
/
1
, Set the mode dial to
press / (self-timer).
The (self-timer) indicator appears on the
screen.
• You can carry out this operation even when the
mode dial is set to P, S, A, M, SCN or
34
2
, and , Center the subject in the frame,
and press and hold the shutter
button halfway down, then
press the shutter button fully
down.
The self-timer lamp (page 9) will flash, and
.
you will hear a beeping sound. The image
will be shot after approximately 10 seconds.
To cancel the self-timer during the
operation
Press /
indicator dissapears from the screen.
• If you stand in front of the camera and press the
shutter button, the focus and the exposure may
not be correctly set.
80 FINE
min 101
8M
98
MAF 250 F2.0 0
EV
(self-timer) again. The

Using the flash

Flash emitter
Hologram AF
emitter
The flash automatically pops up and strobes
when the surroundings are dark. Close the
flash by hand after using it.
• When [ISO] is set to [Auto] in the menu
settings, the recommended shooting distance
using the flash is approx. 0.5 m to 4.5 m
3 1
(19 / inches to 14 feet 9 / inches) (W)/0.6 m
4 4
5
to 3.3 m (23 / inches to 10 feet 10 inches) (T).
8
• Attaching the supplied lens hood blocks the
flash light.
• While the flash is being charged, the
lamp flashes. After charging is completed, the
lamp goes out.
• You can also select the following flash modes:
(Forced flash), (Slow synchro), and
(No flash). For details on these modes, see page
68.
(flash)