Moving To Another Time Zone - Casio 5603 Operation Manual

Adjusting Hand and Day
Indicator Alignment
1.
Pull out the crown to the second click.
2.
Hold down (B) for at least six seconds until
the second hand points to 12 o'clock
twice. Release the button when the
second hand reaches 12 o'clock.
This will start auto alignment of the hour
hand, minute hand, second hand, and 24-
hour hand.
The second hand will point to 12 o'clock
●
once after about three seconds, and
then a second time after about six
seconds.
After auto alignment is complete, the
●
hands should be in the positions shown
below.
24-hour hand
Minute hand Hour hand
30
Second hand
3.
Press (B).
The hour, minute, second and 24-hour
●
hands will move to the 11-minute
position.
When the 24-hour hand is in the vicinity
●
of 14:00, hold down (A) until the hour
hand, minute hand, and 24-hour hand
start to move. Confirm that the 24-hour
hand stops in the vicinity of 02:00.
4.
Press (B).
Confirm that the small hour and minute
hands, and the small 24-hour hand are all
stopped at 12 o'clock.
Small minute hand
Small hour hand
30
Small 24-hour hand
Operation Guide 5603
5.
If the small hour and minute hands, and
the small 24-hour hand are not at 12
o'clock, rotate the crown to align them with
12 o'clock.
6.
Press (B).
Confirm that the mode hand is stopped at
"Su", and check if the day is indicated
properly.
7.
If the mode hand and/or the day indicator
is out of alignment, rotate the crown to
move the mode hand to "Su" and the day
to the center of the indicator window.
The movement range of the mode hand
●
and day indicator is limited when you
rotate the crown. The maximum left-
right movement of the mode hand is 180
degrees in either direction. The day
indicator moves only slightly.
After the mode hand and day indicator
●
are in the positions you want, advance
to step 10 of this procedure. If you are
Crown
unable to make the adjustments you
want, go to step 8.
8.
Press (B).
Confirm that the day indicator shows 1.
Changing the date setting will cause the
●
mode hand to rotate repeatedly. In
some cases, the mode hand may
continue to rotate for about 20 minutes.
Hand and Day Indicator Movement
l
9.
If 1 is not shown for the day, rotate the
crown until 1 is shown for the day.
The mode hand moves in conjunction
●
with crown rotation. Align the mode
hand with "Su".
10.
Push the crown back in.
Day (Operation start day)
30
30
Mode hand
1
1
Day
Note
Leaving the crown pulled out for more
●
than approximately 30 minutes without
performing any operation will
automatically cause the adjustment
operation to become disabled. If this
happens, push the crown back in to its
normal position and then pull it out
again to restart the procedure from the
beginning. Pushing the crown in to its
normal position part way through the
alignment procedure will cause the
hands to return to their normal position.
Any alignment you performed up to
that point will be applied.
Moving to Another Time
Zone
Use the procedure below to easily change day
and time settings of the watch to a destination
location.
Before Boarding
●
1.
Configure the World Time to the current
time at your destination.
Current time
Destination time
Using OCEANUS Connected to
l
Configure Settings
Using Watch Operations to Configure
l
Settings
2.
Disable auto time adjustment.
30
Using OCEANUS Connected to
l
Configure Settings
Using Watch Operations to Configure
l
Settings
15