Using the Watch in a Medical
Facility or Aircraft
Whenever you are in a hospital, on an aircraft,
or in any other location where auto time
calibration signal receive or connection with a
phone may cause problems, you can perform
the procedure below to disable such
operations. To re-enable auto time
adjustment, perform the same operation
again.
1.
Enter the World Time Mode or the
Stopwatch Mode with the stopwatch reset
to all zeros.
Navigating Between Modes
l
Measuring Elapsed Time
l
2.
Press (B).
The second hand will indicate the last
receive result for nine or ten seconds.
30
3.
Within 10 seconds after pressing (B)
above, pull out the crown to the first click.
If more than 10 seconds elapse before
●
you pull out the crown after you press
(B), the second hand will return to
indicating seconds. If this happens,
press (B) again.
4.
Rotate the crown to disable auto time
adjustment.
[Y(YES)]: Auto time adjustment enabled.
[N(NO)]: Auto time adjustment disabled.
30
5.
Push the crown back in.
Note
If the watch is paired with a phone,
●
OCEANUS Connected can be used to
disable auto time adjustment.
Using OCEANUS Connected to
l
Disable Auto Time Adjustment
Operation Guide 5603
Using Mobile Link with
a Mobile Phone
While there is a Bluetooth connection
between the watch and phone, the watch time
setting is adjusted automatically. You can also
change the watch's other settings.
Note
This function is available only while
●
OCEANUS Connected is running on
the phone.
This section describes watch and
●
phone operations.
X : Watch operation
Y : Phone operation
Getting Ready
A Install the required app on your
phone.
In Google Play or the App Store, search for the
CASIO "OCEANUS Connected" app and
install it on your phone.
B Configure Bluetooth settings.
Enable the phone's Bluetooth.
Note
For details about setting procedures,
●
see your phone documentation.
Crown
C Pair the watch with a phone.
Before you can use the watch in combination
with a phone, you first need to pair them.
1.
Move the phone to be paired with close to
(within one meter of) the watch.
2.
Y Tap the "OCEANUS Connected" icon.
3.
Y Perform the operation shown on the
screen of the phone to be paired with.
If a pairing prompt message appears,
●
perform the operation shown on the
phone screen.
If pairing fails for some reason, the
●
watch will return to the state in step 1 of
this procedure. Perform the pairing
procedure again from the beginning.
Note
The first time you start up OCEANUS
●
Connected, a message will appear on
your phone asking if you want to
enable location information
acquisition. Configure settings to allow
background use of location
information.
Auto Time Adjustment
The watch will connect with a phone at preset
times each day and adjust its time settings.
Using Auto Adjust
●
Your watch adjusts its time setting four times
a day according to a preset schedule. If you
leave the watch in the World Time Mode or in
the Stopwatch Mode while it is reset to all
zeros, it will perform the time adjustment
operation automatically as you go about your
daily life, without any operation required by
you.
9