Stopwatch Mode
●
The second hand, and the small hour and
minute hands indicate the elapsed stopwatch
time.
The main hour and minute hands indicate
●
the current time.
①
②
③
④
30
⑤
⑥
A Stopwatch hours
B Stopwatch minutes
C Current location time (24-hour time)
One revolution every 24 hours.
D Stopwatch seconds
The second hand indicates the current
timekeeping seconds while the stopwatch is
reset to all zeros.
E Stopwatch hours (24-hour time)
The hand points to the A-side for hours 0
through 12, and to the P-side for hours 12
through 24.
F Mode hand
Points to [ST] while an elapsed time
measurement operation is in progress. The
mode hand points to the Home City day of the
week while the stopwatch is reset to all zeros.
Operation Guide 5603
Common Operations in All Modes
●
World Time Mode
Start/
Stop
Time Adjustment Using a Time Calibration
Signal
Reset
Hold down (B) for at least 0.5 seconds until the
second hand points to [R].
A manual time calibration signal receive
●
operation cannot be performed while the
watch is paired with a phone.
Checking the Charge Level
Pushing the crown back in after pulling it out
will cause the current charge level to be
indicated by the mode hand.
Checking the Charge Level
l
Connecting with a Paired Phone to Adjust
the Watch's Time
Hold down (B) for at least 0.5 seconds until the
second hand points to [C].
Searching for a Paired Phone
Hold down (B) until the second hand points to
[C] three times.
Using the Crown
Pulling Out and Pushing In the Crown
●
To perform a crown operation, pull it out to the
first or second click and then rotate it. Do not
pull the crown with too much force.
First click
Second click
Important!
To prevent loss of water resistance
●
and/or damage due to impact, be sure
to push the crown in to its normal
position after you are finished using it.
When pushing the crown back in, take
●
care not to apply too much force.
Stopwatch Mode
30
30
Normal timekeeping
Fast Forward/Fast Reverse
●
After pulling out the crown to the first or second
click, rotating it quickly in succession in either
direction will start a fast forward or fast reverse
operation. While a fast forward operation is in
progress, quickly rotating the crown in
succession again will increase the speed even
further.
Stopping Fast Forward/Fast Reverse
●
Rotate the crown in the direction opposite that
of the ongoing operation or press any button.
Note
If you do not perform any operation for
●
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
Hand and Day Indicator
Movement
Day indicator
30
Mode hand
Mode Hand and Day Indicator
●
Movement
Changing the day setting of the watch will also
cause the mode hand to move.
Day
●
It can take anywhere from about one to four
●
minutes for the day indicator to change after
timekeeping reaches midnight. The mode
hand moves as the day indicator changes.
The day may not be indicated correctly
●
while the watch's crown is pulled out.
3