Cable Box Connections; Cable Box - Sony WEGA KV-36XBR250, KV-32XBR250 Operating Instructions Manual

Connecting and Installing the TV (continued)

Cable Box Connections

Some pay cable TV systems use scrambled or
encoded signals that require a cable box to
view all channels.

Cable box

1
Connect the coaxial connector from your
cable to the IN on your cable box.
2
Using a coaxial cable, connect OUT on
your cable box to VHF/UHF on your TV.
Cable box and cable
For this set up, you can switch between
scrambled channels (through your cable box),
and normal (CATV) channels by pressing
ANT on your remote control.
Notes
• Your Sony remote control can be
programmed to operate your cable box,
(see page 34).
• When using PIP, you cannot view the
AUX input in the window picture.
Tip z
Pressing ANT switches between these inputs.
4
If you will be controlling all channel selection
through your cable box, you should consider
using the CHANNEL FIX feature, (see page 26).
Cable
IN
If you are connecting a cable box through the AUX input and
would like to switch between the AUX and normal (CATV) input
you should consider using the CHANNEL FIX feature, (see page 26).
Cable box
IN
75-ohm coaxial cable (not supplied)
CATV cable (unscrambled channels)
(Rear of TV)
VHF/UHF
OUT
Cable box
(Rear of TV)
AUX
OUT
TO CONVERTER
VHF/UHF
(signal)