Furuno Inmarsat Mini-C MES FELCOM19 Installation Manual page 13

2.1.2 Antenna cable 5D/8D-FB-CV (50 m)
Connector type N-P-5D-FB
Outer Sheath
Armor Inner Sheath
50
Cover with heat-shrink tubing and heat.
30
Clamp Nut
Gasket (reddish brown)
Clamp Nut
Dimensions in millimeters.
Shield
30
10
Clamp
Aluminum Foil
Trim shield here.
Insulator
Trim aluminum tape foil here.
1
5
Pin
Shell
Solder through the hole.
How to fabricate antenna cable 8D-FB-CV
Remove outer sheath and armor by the
dimensions shown left.
Expose inner sheath and shield by the
dimensions shown left.
Remove insulator and core by 10 mm.
Twist shield end.
Slip on clamp nut, gasket and clamp as shown
left.
Fold back shield over clamp and trim.
Cut aluminum foil at four places, 90 from one
another.
Fold back aluminum tape foil onto shield and trim.
Expose the insulator by 1 mm.
Expose the insulator by 5 mm.
Slip the pin onto the conductor. Solder them
together through the hole on the pin.
Insert the pin into the shell. Screw the
clamp nut into the shell.
(Tighten by turning the clamp nut. Do not
tighten by turning the shell.)
2. WIRING
2-3