6.3.4
Connecting terminating resistors
Use the CL9-TERM (gray) for the terminating resistors.
For a system configuration using dedicated flat cables only, the CL9-RYVK (black) can also be used.
Note that terminating resistors of the same model must be used for both ends of the trunk line.
(1) Connecting a terminating resistor on the master module side
The following figure illustrates how to connect a terminating resistor.
Connect the terminating resistor within 20cm from the master module using a connector.
Terminating resistor
(2) Connecting a terminating resistor on the end of the trunk line
The following figure illustrates how to connect a terminating resistor to the opposite end of the master module.
46
Within 20cm
Master module
Terminating resistor