Mitsubishi Melsec-L Series User Manual page 44

5)-2 When using a connector for T-branch connection
After removing the sheath by 7cm or more, branch the cable using a connector in the same way as the T-branch connection
method for a dedicated flat cable.
VCTF cable/flexible cable
connector
(c) Building T-branch connection
(Trunk line: Dedicated flat cable, branch line: VCTF cable/flexible cable)
6) Branch the cable using a connector in the same way as the T-branch connection method for a dedicated flat
cable.
(d) Processing the VCTF cable connector/flexible cable connector (for terminating
resistor)
7) Cut the cover edge at the two roots using
a nipper and remove the edge.
Cut
(3) Precautions for use of flexible cables
Prevent an excessive load from being applied to the connector when moving flexible cables.
42
VCTF
cable/flexible cable
connector
VCTF cable/flexible
cable connector
Dedicated flat cable
connector
8) Place the cover at the point
where the terminating resistor
is to be connected.
VCTF cable/flexible cable (trunk line)
VCTF cable/flexible cable (branch line)
Dedicated flat cable
(trunk line)
VCTF cable/flexible
cable
(branch line)
9) Follow the steps (a) 3) and 4).