Use The Remote Control; Pairing The Remote Control - Avaya CU360 Quick Start Manual

USE THE REMOTE CONTROL

The remote control provided in the box is pre-
paired. Please ensure that the batteries are
inserted inside the remote control wireless device.
If a new remote is used, out of the box, please
follow the pairing procedure reported in next
section of this guide.

PAIRING THE REMOTE CONTROL

Your remote control is a wireless control device,
pre-paired with your CU360 unit. If you are using
a new optional remote control, or your remote
control is not paired, please follow the below
procedure.
8
1.
Check that the remote control is equipped
with 2 AAA charged batteries.
2.
Unplug the codec unit from power.
3. Press the Back key and the OK key
together, until the small blue LED on
top of the remote quickly flashes a
few times.
4. While the LED light is still flashing, plug the
codec unit into power while keeping the
remote control close to the unit. The remote
control led should stop flashing to show
successful pair.
5. If the pairing fails, disconnect all the cables
from the CU, including USB and repeat the
procedure.
9