Dhcpv6 Client Setup - ZyXEL Communications XS3800-28 User Manual

The following table describes the labels in this screen.
Table 33 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Setup
LABEL
Interface Type
Interface ID
Neighbor Address
MAC
Add
Cancel
Clear
Index
Interface
Neighbor Address
MAC
Delete
Cancel

8.7.11 DHCPv6 Client Setup

Use this screen to configure the Switch's DHCP settings when it is acting as a DHCPv6 client. Click the link
next to IPv6 Neighbor Setup in the IPv6 Configuration screen to display the screen as shown next.
Chapter 8 Basic Setting
DESCRIPTION
Select the type of IPv6 interface for which you want to configure. The Switch supports the
VLAN interface type for IPv6 at the time of writing.
Specify a unique identification number (from 1 to 4094) for the interface.
Note: A static IPv6 neighbor entry displays in the Management > IPv6 Neighbor
Table screen only when the interface ID is also created in the Basic Setup >
Interface Setup screen.
Note: To have IPv6 function properly, you should configure a static VLAN with
the same ID number in the Advanced Setup > VLAN screens.
Specify the IPv6 address of the neighboring device which can be reached through the
interface.
Specify the MAC address of the neighboring device which can be reached through the
interface.
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if
it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the nonvolatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to reset the fields to the factory defaults.
This is the interface index number. Click on an index number to change the settings.
This is the name of the IPv6 interface you created.
This field displays the IPv6 address of the neighboring device which can be reached
through the interface
This field displays the MAC address of the neighboring device which can be reached
through the interface.
Select an entry's check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Check the entry(ies) that you want to remove and then click Delete to remove the
selected entry(ies) from the summary table.
Click Cancel to clear the check boxes.
XS3800-28 User's Guide
109