Illustration 2 : Observing The Delay Caused By A Sine Wave Signal Passes Through The Circuit - UNI-T UTD4000 Series User Manual

UTD4000 Four-channel User Manual
Peak-to-peak and frequency measurements will now
appear at the bottom of the screen, as shown in
Figure 3-1.
Figure 3-1 Automatic measurement
Illustration 2 : Observing the delay caused by a
sine wave signal passes through the circuit
As in the previous scenario, set the probe attenuation
factor of the probe and oscilloscope channel to 10X.
Connect the CH1 to the circuit signal input terminal
Connect CH2 to the output terminal
Steps :
1. To display CH1 and CH2 signals :
①
Press [ AUTO ].
②
Continue to adjust the horizontal and vertical
range until you get the desired waveform display.
③
Press [ CH1 ] to select CH1. Adjust vertical
position of the CH1 waveform by turning the
vertical position control knob.
④
Press [ CH2 ] to select CH2. In the same way
described above, adjust vertical position of the
CH2 waveform so that the waveforms of CH1 and
CH2 do not overlap. This will make observation
easier.
.
.
81