Cursor Measurement - UNI-T UTD4000 Series User Manual

Cursor Measurement

Press [CURSOR] to display the measurement cursor
and cursor menu, then adjust the cursor position by
turning the MULTIPURPOSE
shown in the figure below
control zone is the
.
measurement
You can move the cursor to carry out measurement in
the [ CURSOR ] mode. There are two modes to choose
from : voltage and time. When measuring voltage,
select voltage for type and adjust the positions of
the two cursors with the
knob to measure V. Likewise, by selecting time
can measure T. The [ CURSOR
modes : independent
,
independent mode you can adjust the positions of
the two cursors independently
,
mode you press the MULTIPURPOSE
to move two cursors simultaneously
74
.
control knob
, [ ]
CURSOR in the
function key for cursor
MULTIPURPOSE control
,
you
] menu has two other
.
and tracking In the
.
In the tracking
control knob
.
UTD4000 Four-channel User Manual
As
Figure 2-27 Function key for the sampling
system (cursor)
Notes :
1. In the independent or tracking mode, select one of
the cursors with the
The selected cursor is a solid line. Adjust its
position with the
2. There are two percentage options. The current
status is 100%. The
cursors is set to 100%
and the other is 100%
, ±
DIV the 3DIV area on the screen is 100%.
3. When the cursor function is enabled, measurement
value is automatically displayed in the top left
corner. @ is the selected cursor value.
MULTIPURPOSE control knob
MULTIPURPOSE control knob
value between the two
, . .
i e one cursor is 0%
.
When 100% is set to 6
.
.