Initial Setup - Priority Commands / Queries - Comtech EF Data SLM-5650C CyberLynx Installation And Operation Manual

7.5.2 Initial Setup – Priority Commands / Queries
Before executing any Modem, Unit, Bulk/Global, AUPC, or Optional Interface commands/queries, initial setup should be accomplished with
these three commands, prioritized as follows: (Highest Priority) MOM, RFB, ITF (Lowest Priority). Priority commands are indicated by
throughout these sections. Any change to a higher priority parameter can override any of the parameters of lower priority.
Command Arguments for
Parameter (Instruction Command or
Type Code and Response to
Qualifier) Query
Modem MOM= 1 byte
Operating
Mode
Modem RF N/A 1 byte
Band
Interface ITF= 1 byte
Type
Serial Remote Control
Description of Arguments
Command or Query.
Modem Operating Mode, where:
0=OM-73
1=Mil-165A
2=IESS-308
3=IESS-309
4=IESS-310
5=TURBO
6=16QAM
7=AUPC
8=RXBURST
9=TXBURST
A=TURBO-FA
B=RXBRSTFA
C=LDPC
Example: MOM=0 (sets OM-73 operating mode)
Query Only.
Modem RF Band, where:
0=Reserved
1=L-Band (950 MHz – 2000 MHz)
Command or Query.
Interface Type, where:
4=GigaBit Ethernet Interface
7=LVDS Test Interface
Example: ITF=4 (sets GigaBit Ethernet interface type)
SLM-5650C / SLM-5650C-ODU Satellite Modem
7–11
Revision 1
Query
Response to (Instruction Response to
Command Code and Query
Qualifier)
MOM= MOM? MOM=x
MOM? (see Description of
MOM* Arguments)
MOM#
RFB? RFB =x
(see Description of
Arguments)
ITF= ITF? ITF=x
ITF? (see Description of
ITF* Arguments)
ITF#
MN-SLM-5650C
shading